Keep your cuppa nice and warm using our step-by-step guide.
Step 1 Step 2
Step 3 Step 4
MAKE A... MUG WRAP
COPY, enlarge and print off the template onto
white paper. Place on your stitching. Hold up to
the light, and then pin the template to your
stitching with the design in the centre. Cut out,
adding a 1cm (⅜in) seam allowance. Repeat for
the backing fabric.
PIN the stitching and backing fabric together
and then insert an elastic hair bobble into the
seam at one short end of the mug wrap – do not
cut the bobble as it will lose strength, just
position it halfway through the seam, as shown
in the photograph.
STITCHaround the edge of the wrap, with a 1cm
(⅜in) seam allowance, leaving a gap at one short
end, opposite the bobble. Clip the curves and
corners and reduce the seam allowance, then
turn through to the right side. Sew up the gap.
PLACE the wrap around your mug, and then
using a pin, mark the position of the button to
correspond with the bobble closer. Sew the
button in position on the edge of the wrap.
Your wrap is now ready to use!
Template
Enlarge your
template by 200%
S
u
sa
n
P
e
n
n
y