MOBILE PHONE DANGLE
STEP ONE
Lay out your pattern as shown in the
photograph. Thread 1 x crimp on one end of
the Beadalon wire, thread Swarovski flower
through one of the petals. Thread the wire
backthroughthecrimpallowing1.5cmof excess wire making sure the wires are
parallel. Squash the crimp with the pliers.STEP TWO
Thread on your pattern, thread the excess
wire through the beads also.STEP THREE
Cut off the excess wire approx. 2cm. Thread
crimp the mobile phone strap at the split ring
end and thread wire back through the crimp
keeping the wires parallel before you squash
the crimp. Hold the excess wire end of the
loop with the pliers and direct the excess wire
back through the beads, making the loop
smaller (approx. the same as the first loop).STEP FOUR
Squash crimp with pliers.KEYRING DANGLE
STEP ONE
Lay out your pattern as in the photograph.
Thread 1 x bead cap, 18mm faceted
barrel followed by second bead cap onto
head pin.STEP TWO
Form a wrapped loop on top of head pin
from step one.STEP THREE
Thread 1 x crimp onto end Beadalon wire.
Thread wire wrapped crystal, thread back
through the crimp allowing approx. 1.5cm
of excess wire, making sure the wires are
parallel. Squash the crimp.STEP FOUR
Thread on pattern, making sure the excess
wire goes through the beads.Try one of these dangle designs by Carol Robinson
and Cara Withnell from Bead and Crystal Heaven.
PROJECT
Rating
56 Creative Beading
MOBILE PHONE
DANGLE
MATERIALS
1x 5cm mobile phone strap
10cm x Beadalon 0.018’’
2 x crimps
BEADS
1x 10.5x7 Swarovski barrel
crystal AB
1x 8mm Swarovski lt grey
pearl
1x 8mm Swarovski black
diamond bi-cone
1x 8mm Swarovski rhodium
crystal ball
1x 8mm Swarovski silver
shade rondelle briolette
1x Swarovski diamante
flower rhodium crystal
TOOLS
Chain nose pliers
Beading board or mat
KEYRING
DANGLE
MATERIALS
1 x 57mm swivel clip
1 x 25mm split ring
6 x chain links (2.5cm)
2 x Bali bead caps
50mm head pin
10cm x Beadalon 0.018’’
Crimps
Continued ...