You will need
● white 10.5x15cm
card blank
● mixed-media paper
● navy, grey, dark yellow &
pale yellow cardstock
● gold mirror card
● Woodware Fill Me
Lightbulb stamp set
● Waterproof inkpad &
embossing inkpad
● Ranger UTEE
embossing enamel
● watercolour markers
● Lemon Tonic & Midnight
Spectrum Noir Harmony
Opaque pigment inkpads
● enamel dots
● waterbrush
● 3D foam pads
● heat tool
Simply make
1 Cut a 10x14cm piece
of mixed-media paper
to measure. Cut 0.5cm
Happy birthday
and place over the top of
the image.
2 Stencil the brick wall
image ono the panel –
the mask over the lightbulb
will ensure the image
stays white.
3 Remove the mask and
colour the image with
watercolour pens and
the waterbrush.
4 Smoosh inkpads on a
glass mat and dilute with
a little water from the
waterbrush and ick ink
speckles onto the card.
Ink around the edges
with blue ink.
5 Sprinkle embossing
enamel onto the
background and melt from
underneath. Layer onto
navy cardstock, leaving a
narrow border, and add
to the card front.
6 Stamp the sentiment
onto white cardstock, trim
into a banner and ink the
edges before mounting in
place using 3D foam pads.
Finish the card front with
an enamel dot.strips of coloured
cardstock and mirror
card and adhere at an
angle to backing card to
make stripes
2 Smoosh inkpads onto
a glass mat and dilute
with a little water,
icking onto the panel
to create ink specks.
3 Ink around edges of the
white panel and adhere
on to navy card, leaving
a narrow border before
adding to the card front.
4 Stamp the bulb and
sentiment onto white
cardstock and colour.
Cut out and emboss
several times with
embossing enamel.
5 Add the bulb to card
front using 3D foam
pads and nish with
enamel dots as shown.You will need
● white 10.5x15cm
card blank
● navy cardstock
● mixed-media paper
● Post-it note
● Woodware Fill Me
Lightbulb stamp set
● Heffy Doodle Brick By
Brick stencil
● Aged Gold Stampendous!
Frantage embossing
enamel
● black waterproof inkpad
● watercolour markers
● Lemon Tonic & Midnight
Spectrum Noir Harmony
Opaque pigment inkpads
● Clearly besotted Sweet
Little Sentiments stamps
● enamel dots
● waterbrush
● 3D foam pads
● heat toolSimply make
1 Cut a 10x14cm piece of
mixed-media paper to
measure and stamp
the lightbulb in the centre
of the panel. Create a
mask using a Post-it noteShine
Use tweezers to hold the
lightbulb on a heatproof surface
when melting the UTEE, add the second layer
of powder when the first layer is moltenTop tip