Masculine makes
Recycle acetate from packaging
for your shaker windowsYou will need
● white 15.24cm-square
card blank
● mixed-media paper
● Post-it notes
● grey cardstock
● gold mirror card
● Woodware Fill Me
Lightbulb stamp set
● waterproof inkpad
● watercolour markers
● Clearly Besotted Sweet
Little Sentiments stamp set
● Lemon Tonic, Midnight,
Honeypot Spectrum Noir
Harmony Opaque
pigment inkpads
● enamel dots
● sequins
● waterbrush
● heat tool
Simply make
1 Cut mixed-media paper
slightly smaller than the
card front. Stamp two
lightbulbs and the lament
sentiment into one.
Hugs & kisses
Brilliant
You will need
● white 13.5cm-square card blank
●Woodware Fill Me
Lightbulb stamps
● navy & yellow cardstock
● gold mirror card
● mixed-media paper
● acetate
● waterproof inkpad
● Lemon Tonic & Midnight Spectrum
Noir Opaque pigment inkpads
● sequins
● waterbrush
● 3D foam pads
● heat toolSimply make
1 Cut a 12cm square of mixed-media
paper, stamp with the bulb
image and cut out to create a
shaker aperture.
2 Place a piece of white cardstock
under the aperture and trace with a
pencil. Stamp the sentiment and ink
under it using yellow ink.
3 Add 3D foam tape around the
pencilled line of the bulb and add
sequins. Colour the bulb to create a
background with ink, blending yellow
and blue around the edges. Add ink
splatters using a waterbrush.
4 Add acetate behind the aperture and
adhere onto the shaker base. Layer
onto gold card, leaving a narrow
border and then on navy and yellow
card before adding to the card front.2 Stamp lightbulbs again
onto Post-it notes, cut
out and use to mask the
stamped images.
3 Create beams of light from
each bulb using different
shades of yellow ink.
Remove the masks and
colour the lightbulbs with
watercolour markers and
a waterbrush.
4 Smoosh inkpads onto a
glass mat and dilute with a
little water, ick ink onto the
panel to add specks of ink.
5 Ink around the edges and
mount onto mirror and grey
cardstock, leaving a narrow
border. before adding to the
card front.
6 Stamp the sentiment
and cut it into a label
shape. Ink around the
edges and add to the card
front using 3D foam pads.
Finish with an enamel dot
and sequins.