Technique
Hang in there
You’ll need
● white 5x7” card blank
● white stamping cardstock
● pink cardstock
● Altenew Hang In There die
● Crystal Clear Spectrum Noir
Sparkle Pen
● Sweet Lilac Nuvo
Crystal Drops
● offcuts from One friend
card (above)
● 3D foam pads
● manual die-cutting machineSimply make
1 Matt the second-generation
stamped outside panel onto
pink cardstock and adhere
to the card front using 3D
foam pads. Matt the fullTap the
card lightly
onto a solid surface after
applying Nuvo Drops to
get an enamel-style dotTop tip
One friend
You’ll need
●white 5x7” card blank
● white stamping cardstock
● pink cardstock
● Altenew Peony Bouquet &
Stunning Cosmos stamp sets
● Altenew One Friend mini
stamp set
● Creative Dies Plus Stitched
& Pierced Rectangles
nesting die sets
● Puffy Heart, Purple Wine,
Cosmic Berry, Evergreen,
Forest Glade, Fresh Lemon,
Honey Drizzle & Orange
Cream Altenew inkpads
● Onyx Black VersaFine inkpad
● clear embossing powder
● stamp-positioning tool
●Post-it notes
● 3D foam pads
● heat tool
● manual die-cutting machine
Simply make
1 Cut two 6¼x4¼” pieces of
white stamping cardstock.
Use Puffy Heart ink to stamp
the large ower and three
daisies with Puffy Heart
ink, then stamp again onto
the second piece to get a
lighter shade. Repeat with
the smaller ower, adding
the layering details.
2 Stamp the solid images onto
Post-it notes and cut out.
Cover all of the rst- and
second-generation owers
with the Post-it note masks
then stamp the leaves as
shown with Forest Glade
ink, both in rst and second
generation on the second
card piece. Add the layering
stamps using Evergreen ink
in the same way.
3 Use Fresh Lemon ink to add
the berries to the image
and Orange Cream ink to
the layering stamp image.
Remove the masks and
add Fresh Lemon ink to
the daisy centres and
use Honey Drizzle inkfor the layering stamp.
4 Place the two stamped
panels together. Secure the
fourth-largest rectangle die
in the centre of the card and
die-cut. Remove the die and,
if it hasn’t cut through the
second card piece properly,
line the die up with the
impression left and
die-cut again.
5 Take the full-generation
outside piece and layer ontopink cardstock then adhere
to the card front. Take the
second- generation inside
panel (set the other pieces
aside for the next project)
and stamp the sentiment
using VersaFine ink. Heat-
emboss using clear powder.
6 Layer onto pink cardstock
and use 3D foam pads to
adhere to the card front,
ensuring the owers line
up with each other.generation centre piece onto
pink cardstock and adhere to
the centre of the card front
using 3D foam pads.
2 Die-cut the sentiment three
times from white cardstock,
adhere together for added
dimension then attach in
the centre of the panel.
3 Cover the sentiment die-cut
with a clear sparkle pen then
add Sweet Lilac Nuvo Drops
to the design to nish.