LACE
YARN USED
TOFT DK yarn
1 ball in Shale
ABOUT THE YARN
DK; 225m per 100g ball;
100% wool
TENSION
22 sts x 30 rows = 10cm
over St st
NEEDLES USED
3.75mm DPNs
OTHER SUPPLIES
stitch marker
TOFT alpaca pompom
SIZING
34cm wide x 22cm high
(laid flat)
ABBREVIATIONS
See page 27 for all abbreviations
Cast on 100 sts. Join to work in the rnd,
being careful not to twist. Pm to mark beg
of rnd.
Work k2, p2 rib for 6cm.Rnd 1: *K2, yo, k2tog; rep from
* to end.
Rnd 2: Knit.
Rnd 3: *K2, k2tog, yo; rep from
* to end.
Rnd 4: Knit.
Rep rnds 1-4 until hat measures
16cm, ending after a Rnd 4.Shaping
Next Rnd: *K2tog, yo, k2tog; rep from * to
end. 75 sts
Next Rnd: Knit.
Rnd 1: *K1, k2tog, yo; rep from
* to end.
Rnd 2: Knit.
Rnd 3: *K1, yo, k2tog; rep from
* to end.
Rnd 4: Knit.
Rep rnds 1-4 until work measures 22cm,
ending after a Rnd 4.Crown shaping
Rnd 1: *K1, k2tog, k1, yo, k2tog;
rep from * to last 3 sts, k1, k2tog.
62 sts
Rnd 2 & all even rnds: Knit.
Rnd 3: *K2tog, k1, k2tog, yo; rep from * toThis hat uses basic lace
techniques in columns to
create a delicate finish
Yarn over (yo)
Between knit sts
Start with yarn at back. Bring yarn forward
from back to front between the needles
and back over the RH needle and hold to
back ready to knit next st.last 2 sts, k2tog. 49 sts
Rnd 5: *K2tog, yo, k2tog; rep from * to last
st, k1. 37 sts
Rnd 7: *K1, k2tog, yo; rep from * to last
st, k1.
Rnd 9: *K1, k2tog; rep from * to last st,
k1. 25 sts
Rnd 11: [K2tog] 12 times, k1. 13 sts
Break yarn and thread through
rem sts. Pull tight to fasten.Finishing
Weave in ends and block to
measurements. Attach pompom.