and the carburetor linkage off the fast idle cam and set to the correct
idle speed. After these conditions are reached, shut off the engine and
connect a stroboscopic timing light in accordance with manufacturer’s
directions. Also, disconnect and plug the vacuum connections to the
distributor vacuum advance mechanism. Then, re-start the engine, verify
that the idle speed is correct, and point the light at the timing mark. The
timing light will emit a flash of light every time the number 1 plug fires
and the timing mark will appear stationary opposite its pointer. If the
correct timing specification is not observed, move the distributor
clockwise or counterclockwise until the mark is at its proper position.
Then, tighten the clamp on the distributor and double-check the reading.
singke
(singke)
#1