The Cure for All Cancers

(pavlina) #1

THE CURE FOR ALL CANCERS


tucked snugly under the edges. You have just made yourself a
set of open capacitors.
Mount these on the bottom of a shoe box turned upside
down. They should be at least two inches apart. Make a hole
through each with a small nail, and enlarge with a pencil point
until you can fit a small bolt through. Use a washer and a nut to
tighten them down. The bolt should be at least one inch long, to
make it easy to clip leads to inside the box.
Mount two ordinary light switches on the front side of the
shoe box, one in front of each plate. Cut 1 by ½ inch rectangu-
lar holes to let the toggle through. Remove the screws that came
with the switch, then insert the switch from inside so that OFF
is when the toggle is UP (this is the reverse of how most light
switches are oriented). Push a pin from the inside through the
screw holes, enlarge them, and replace the screws from the out-
side. If the shoe box is too shallow, flex the “ears” off the
switches.
On the shoe box, label the left plate “Substances” and the
right plate “Tissues”. Label the toggle for each plate with an
“OFF” and “ON”.
Using a short alligator clip test lead, attach the tissue plate
bolt to the tissue switch at one screw terminal. If there are three
screw terminals, one will be green for ground—do not use it,
use the other two. Attach the other screw terminal on the tissue
switch to the substance plate bolt. Attach the substance plate
bolt to the substance switch at one screw terminal. Finally at-
tach a long alligator clip test lead to the other substance switch
screw terminal. The other end will be attached to the circuit
when you build it.


Choose either the “Acceptable” or the “Best” construction
technique. You do not have to do both.

Free download pdf