Step 7
With all the holes drilled, we need to sand all the parts of our pencil
holder. Use your sanding block for the flat parts and a sanding sponge
ontheedgesofthecircleparts(iftheyneedfurthersanding),butdon’t
sand off your alignment marks, you’ll need those later. Here’s a helpful
trick to help you sand all those holes you’ve drilled. Tear off a small
piece of sandpaper that will just wrap around a pencil. While holding
the pencil and sandpaper together run the pencil up and down in the
holes to get all the little splinters out.
Step 8
Let’s put it all together! Take the washer and place it over the hole on
the base piece. Next, with the center dowel just pushed in to the bottom
piece, spread glue around the dowel. Push the dowel through the
washer and into the base piece.IMPORTANT! Make sure you don’t get