Knitting - UK (2021-07)

(Antfer) #1
82 knittingmag.com

PATTERNS

cm


1

2

3

4

(^52)
6
7
8
9
10
11
12
13
14
16
15
18
17
20
19
22
21
24
23
26
25
28
27
29
9
11
1
in
3 4 5 6 7 8
10
Row 7: K1 tbl twice, yo, pktbl, p1, k1 tbl 3
times, p1, k2tog tbl, yo, k1 tbl; rep from
,
ending last rep with k1 tbl twice.
Row 9: K1 tbl twice, yo, k2tog tbl, p1, k1
tbl 3 times, p1, pktbl, yo, k1 tbl; rep from
,
ending last rep with k1 tbl twice.
Row 11: Rep row 9.
Row 12: Rep row 2.
BAG PANEL (MAKE 2)
Cast on 53 sts.
Starting with a k row, work in st st for 2 rows.
Set Snowdrop St
Using Chart or written instructions, work
in Snowdrop St until work meas 22cm
(8¾in) from cast-on edge, ending after a
WS row.
Eyelets row (RS): K6, (k2tog, yo, k6)
5 times, k2tog, yo, k5.
Work in g st for 10 rows.
Cast off.
LOOP
Cast on 20 sts.
Knit 2 rows.
Cast off.
TO FINISH
Block and press edges under a dry cloth,
pin and sew the bottom seam using
backstitch, press the seam, pin and sew
the side seams using mattress stitch.
Sew in the loop.
Cut a piece of lining fabric the width of
the wash bag plus seam allowances, and
twice the depth of the wash bag plus seam
allowances. Cut a piece of wadding the
same size as the lining fabric.
With the lining fabric on top of the
wadding, fold over one of the top edges
and sew in place. Put the lining inside
the bag and fold over and pin the second
top piece to fit just below the top of the
knitted bag. It is better to have the lining
slightly shorter than the bag to stop it
being loose at the top. Sew in place.
Pin side seams, try inside the wash bag
and adjust to fit. It is better to have the
lining slightly narrower than the wash bag
to stop it being loose, so that the knitted
piece is eased to fit the lining piece. Sew
the side seams. Pin the lining into the wash
bag and hand-sew in place.
Tie
Cut 8 strands of yarn 85cm (33½in) long.
Plait to form a tie.
Thread through eyelets.
Snowdrop Stitch Key
RS: knit, WS: purl
RS: purl, WS: knit
k1 tbl
k2tog tbl
yo
pktbl
10-st patt rep
SOOTHING SLIP
STITCHES BLANKET
BY B E R N AT
SIZE
Approx 131 x 143.5cm (51½ x 56½in)
YOU WILL NEED
Bernat Blanket 100% polyester
(approx 201m per 300g)
3 x 300g balls in 10044 Dark Gray (A)
2 x 300g balls in 10734 Light Teal (B)
1 x 300g ball in 10874 Burnt Mustard (C)
9mm circular needle 91.5cm long
Note: Yarn amounts given are based
on average requirements and are
approximate.
TENSION
8 sts and 16 rows to 10cm over slip st patt.
Use larger or smaller needles if necessary
to obtain correct tension.
ABBREVIATIONS SEE PAGE 91
PATTERN NOTE
When slipping sts, hold yarn at back of
work on RS and at front of work on WS.
STRIPE PATTERN
Work 28 rows A.
Work 32 rows B.
Work 32 rows A.
Work 32 rows C.
Work 32 rows A.
Work 32 rows B.
Work 28 rows A.
These 216 rows form stripe patt.

Free download pdf