Here are the steps involved in building the circuit:
- Place the two LM385 ICs (IC1 and IC2) and 11 terminal blocks on the
breadboard, as shown in Figure 5-4.
As you can see in this figure, each terminal block has connections for two
wires. Here’s what the wires get from each block will be connected to:- Wires from one of the terminal blocks on the right side of the figure
go to the battery pack. - Wires from the other terminal block on the right go to the
microphone. - Wires from the terminal blocks in the center go to the potentiometers.
- Wires from the terminal blocks on the left side of the breadboard
go to the LEDs.
- Wires from one of the terminal blocks on the right side of the figure
- Place the eight 2N3904 (Q1–Q8) transistors on the breadboard, as
shown in Figure 5-4.
IC 2 IC 1
Q5 Q6 Q7 Q8
Q1 Q2 Q3 Q4
Figure 5-4:
Place the
LM385 ICs,
2N3904
transistors,
and terminal
blocks.
Chapter 5: Making Light Dance to the Music 95