- Insert wires to connect IC2 to the transistors and the base pins of the
transistors to each other, as shown in Figure 5-9. - Insert three 0.1 microfarad capacitors (C1, C4, and C6), two 10 micro-
farad capacitors (C2 and C5), and one 0.001 microfarad capacitor (C3)
on the breadboard, as shown in Figure 5-10.
Use both the schematic and the photo to place each component. For
example, the schematic shows that the + side of C2 is connected to Pin 1
of IC1 and that the other side of C2 is connected to potentiometer R7, so
insert the long lead of C2 in the same row as the wire connected to pin 1
of IC1 and the short lead in the same row as the wire connected to the
terminal block for potentiometer R7.
Pin 6 of IC2 to open region
Pin 5 of IC2 to open region
Potentiometer R24 terminal block to open region Pin 7 of IC1 to open region
Pin 6 of IC1 to open region
Connecting two rows
Pin 2 of IC2 to open region
Pin 3 of IC2 to open region
Potentiometer R7 terminal block to open region
Pin 1 of IC1 to open region
Pin 2 of IC1 to open region
Microphone terminal
block to open region
Figure 5-8:
Hook up the
IC, terminal
blocks, and
discrete
components.
98 Part II: Sounding Off!