- Drill a^3 ⁄ 8 " hole about eight inches from the end in the side of the
PVC pipe that will be to your left when you’re holding the parabolic
microphone.
You use this hole to feed the wires from the microphone cartridge to the
box containing your circuit. - Slip one of the gaskets over the threads on the 1" x^3 ⁄ 4 " fitting. Then slip
the threads from the inside through the hole in the dish. - Slip the other gasket over the threads and then screw the 1" x 1" fit-
ting onto the threads. - Tighten the fitting by hand so that the gaskets are compressed a little
and the dish is held securely between the gaskets.
Figure 6-11 shows the handle assembled on the dish.
Mounting the microphone
The microphone is what makes this project work. The first step here is to
make the microphone mounting. Follow these steps:
Figure 6-11:
Fittings
assembled
on the
parabolic
dish.
128 Part II: Sounding Off!