- Secure the wires with wire clips where needed.
The way that parts are laid out in this box as well as the distance between
some of the components — such as from the phono jacks to the terminal
blocks — are both short enough that you won’t need wire clips. - Slip the box onto the PVC pipe and tighten the clamp screws.
Don’t tighten them too much; you still need to slide the box into its final
position. - Put batteries in the battery pack and put the lid on the box, securing
it with the screws provided with the box. - Slide the box into its final position just below the hole where the
phono jacks come out of the PVC pipe. Then insert the phono plugs
and headphone plug into the jacks in the box, as shown in Figure 6-19. - Glue the 1" PVC end cap on the end of the PVC pipe.
You can see the finished product at the beginning of the chapter in
Figure 6-1.
Figure 6-19:
The
electronics
in place.136 Part II: Sounding Off!