- Place five terminal blocks on the breadboard, as shown in Figure 11-9.
The five terminal bocks shown in this figure will be used to connect two
wires each to various components in the circuit. The wires go to the bat-
tery pack, IR LED, on/off switch, motor R switch, and motor L switch,
respectively. - Insert wires to connect each component and terminal to the ground
bus and insert a wire between the two ground buses to connect them,
as shown in Figure 11-10.
On the resonator, the center of the three leads is the ground lead.
Eight shorter wires connect components to ground bus; the long wire on
the left connects the two ground buses.Figure 11-9:
Add
terminal
blocks
to the
breadboard.
Chapter 11: Controlling a Go-Kart, Infrared Style 251