- Insert wires to connect each component to the + voltage bus and a
wire to connect the two + voltage buses, as shown in Figure 11-27.
Note that you connect the +5 volt output of the voltage regulator to the +
voltage bus because the voltage regulator takes the approximately +6
volts from the battery and changes it to +5 volts. It then supplies those +5
volts to the + voltage bus so that it can be used by the other components.Figure 11-27:
Connect
components
to the
+V bus.
Figure 11-26:
Insert
terminal
blocks
on the
breadboard.
Chapter 11: Controlling a Go-Kart, Infrared Style 263