- Solder 12" wires to each of the two inductor leads, as shown in Figure
12-14. Slip a 1" segment of heat shrink tubing over each solder joint
and use a hair dryer to secure the tubing in place. - Twist together the free ends of the wires from the inductor and feed
them through the PVC pipe from the coil end until the end of the wire
strand reaches the^3 ⁄ 8 " hole. - Form a hook shape with a piece of 20 or 22 gauge wire and pull the
wires through the^3 ⁄ 8 " hole. - Insert the inductor in the end of the 1" PVC pipe, as shown in Figure
12-15, and use some glue to secure the inductor in the pipe.
Figure 12-14:
Wires
attached to
inductor.296 Part IV: Good Vibrations