TOYOTA PREVIA 91-97 REPAIR MANUAL

6-58 CHASSIS ELECTRICAL Troubleshooting Basic Turn Signal and Flasher Problems Most problems in the turn signals or flasher s re ...

MANUAL TRANSMISSION 7-2 UNDERSTANDING THE MANUAL TRANS- MISSION 7-2 BACK-UP LIGHT SWITCH 7-2 REMOVAL & INSTALLATION 7-2 EXTE ...

7-2 DRIVE TRAIN MANUAL TRANSMISSION Understanding the Manual Transmission Because of the way an internal combustion engine breat ...

DRIVE TRAIN 7-3 Starter Control Cables Engine Rear Mounting eft Speed Sensor Connector Clutch Release Cylinder End Plate 37 (380 ...

7-4 DRIVE TRAIN Fig. 2 On the 4WO models, remove the front propeller sh bracket 90917G42 Fig. 3 Disconnect the hose and unbolt t ...

DRIVE TRAIN 7-5 Outer Race | 4 Snap Ring Inboard Joint inboard Joint Boot Boot Clamp Non-reusable part Outboard Joint Boot Dri ...

7-6 DRIVE TRAIN Fig. 13 Place matchmarks on the halfshaft and side gear assem- blies Fig. 14 Loosen and remove the bolts on the ...

DRIVE TRAIN 7-7 On models with a ABS speed sensor, secure the sensor to 69 inch Ibs. (8 Mm). Install the front wheel, hand tigh ...

7-8 DRIVE TRAIN Matchmar Fig. 22 With a brass bar and hammer, tap the joint hard e to remove ough Assemble the inboard joint to ...

DRIVE TRAIN 7-9 Driven Disc and Pressure Plate REMOVAL & INSTALLATION I See Figures 24 thru 35 Remove the transmission asse ...

7-10 DRIVE TRAIN Fig. 29 Be sure that the flywheel surface is clean, before installing the clutch Fig. 30 Check across trie flyw ...

DRIVE TRAIN 7-11 Fig. 35 Grease points of the release fork Push Rod Play Adjust Point Pedal Height Adjust Point Push Rod Play 90 ...

7-12 DRIVE TRAIN 25 mm (0.98 in.) or mor« ease Full Stroke End Position Fig. 38 Gradually depress the clutch pedal and measure t ...

DRIVE TRAIN 7-13 Fig. 41 The clutch accumulator is located near the carbon canis- ter Fig. 42 Have an assistant pump the clutch ...

7-14 DRIVE TRAIN ONE-WAY CLUTCH HOUSING FLUID ENGINE CRANKSHAFT TURBINE SHAFT Fig. 44 The torque converter housing is rotated by ...

DRIVE TRAIN 7-15 SUN GEAR HELD RING GEAR DRIVES PLANET CARRIER DRIVEN TCCS7014 Fig. 47 Planetary gears in the minimum reduction ...

7-16 DRIVE TRAIN Fig. 5D Disconnect the lines on the oil cooler Fig. 53 Remove the nut on the neutral safety switch Fig. 51 Remo ...

DRIVE TRAIN 7-17 Fig. 56 Extract the switch from the transmission Unstake the lockwasher. Remove the nut and bolt, then extract ...

7-18 DRIVE TRAIN _0il Cooler Pipe (2WD) Oil Cooler Pipe (4WD) Filler Tube -Rear Mounting Torque Converter Converter Cov Starter ...

DRIVE TRAIN 7-19 Support the transmission, using a jack with a wooden block placed between the jack and the transmission pan. R ...