TOYOTA PREVIA 91-97 REPAIR MANUAL

8-24 SUSPENSION AND ST:ERING Fig. 69 ... then install a puller Fig. 70 Lift the steering wheel off the shaft Fig. 71 Always read ...

SUSPENSION AND STEERING 8-25 Turn Signal (Combination) Switch REMOVAL & INSTALLATION See Figure 72 Without Airbag System T ...

8-26 SUSPENSION AND STiERING Red Mark Fig. 74 Always align the red mark on the spiral cable Remove the instrument lower finish ...

SUSPENSION AND STEERING 8-27 Fig. 75 Remove the cotter pin and discard it Fig. 78 Place a puller between the knuckle and end ... ...

8-28 SUSPENSION AND STEERING Fig. 81 Now pull the end off the steering rack Fig. 82 Each tie rod is marked with an L or R for le ...

SUSPENSION AND STEERING 8-29 Pressure and Return Tube it (ISO, 331~ No. 2 Equipment Drive Housing Insulator LH Engine Under Cove ...

8-30 SUSPENSION AND STEERING Engine Cooling Fan with Coupling 48(490. 35) 36(370.27) Stay N-m (kgf-cm, fMbfjj : Specified torque ...

SUSPENSION AND STEERING 8-31 TORQUE SPECIFICATIONS Components Front Suspension: Axle hub bearing lock nut (2WD) Tie rod end-to-s ...

8-32 SUSPENSION AND STEERING Troubleshootir nrfOOIitH i,i, •. Chirp noise in steering pump • Loose Belt squeal (particularly not ...

BRAKE OPERATING SYSTEM 9-2 BASIC OPERATING PRINCIPLES 9-2 DISC BRAKES 9-2 DRUM BRAKES 9-2 POWER BOOSTERS 9-3 BRAKE LIGHT SWITCH ...

9-2 BRAKES BRAKE OPERATING SYSTEM Basic Operating Principles Hydraulic systems are used to actuate the brakes of all moderil] au ...

BRAKES 9-3 these links bear directly against the top of the brake shoes, the tops of the shoes are then forced against the inner ...

9-4 BRAKES Fig. 3 Disconnect the level warning harness from the brake master cylinder Fig. 4 Siphon out the old brake fluid from ...

BRAKES 9-5 Fig. 9 Extract the master cylinder from the four studs from the brake booster Fig. 10 Remove and discard the old gask ...

9-6 BRAKES Fig. 12 Remove the clip to slide the clevis pin out of the clevis pedal SST Gasket Fig. 13 Install the tool on top of ...

BRAKES 9-7 Fill the brake master cylinder with fresh brake fluid, then bleed the brake system. Check and adjust the fluid press ...

9-8 BRAKES Front brake pressure kPa (kgf/cm', psi} 8,826 (90, 1,280) Rear brake pressure kPa (kgf/cm', psi) 6,659 - 7,639 (67.9 ...

BRAKES 9-9 Fig. 25 Use a brush to clean the fittings of any debris Fig. 28 Inspect the hose threads and pipe ends when they are ...

9-10 BRAKES Fig. 31 Remove this bolt... ' ' l Fig. 34 Any gaskets/crush washers should be replaced with new ones during installa ...

BRAKES 9-11 Thoroughly clean the surrounding area at the joints to be disconnected. Place a suitable catch pan under the joint ...