TOYOTA PREVIA 91-97 REPAIR MANUAL

DRIVE TRAIN 7-29 Remove the caliperand disc. Loosen the 2 nuts on the lower side of the shock absorber. -»Do not remove the bol ...

7-30 DRIVE TRAIN Fig. 98 Tapping in a new dust deflector Companion Range Oil Sllnger Non-reusable part Fig. 99 The front 4WD dif ...

DRIVE TRAIN 7-31 SST Fig. 102 ... then extract the oil seal using a puller bolts, 6 cushions and collars. Lower the jack and rem ...

7-32 DRIVE TRAIN REAR AXLE Axle Shaft, Bearing and Seal I See Figure 106 REMOVAL & INSTALLATION With Drum Brakes I See Figur ...

DRIVE TRAIN 7-33 Fig. 107 Use a slide hammer puller to extract the axle shaft from the housing w/ABS SST Fig. 108 Press out the ...

7-34 DRIVE TRAIN Fig. 110 These four nuts retain the backing plate on the axle rear *# WARNING When removing the bearing, be car ...

DRIVE TRAIN 7-35 SST Fig. 113 Use a screw type puller and remove the companion flange... Fig. 116 Use a torque meter to measure ...

7-36 DRIVE TRAIN /^ Brake Drum Axle Shaft and Brake Assembly «•""' 4 Non-reusable part Fig. 117 Exploded view of the rear axle a ...

8-2 8-2 8-10 WHEELS 8-2 WHEEL ASSEMBLY 8-2 REMOVAL & INSTALLATION INSPECTION 8-2 WHEEL LUG STUDS 8-2 REMOVAL & INSTALLAT ...

8-2 SUSPENSION AND STBERING WHEELS Wheel Assembly REMOVAL & INSTALLATION from their »See Figure 1 Park the vehicle on a lev ...

SUSPENSION AND STEERING 8-3 STUD ROTOR Fig. 2 View of the rotor and stud assembly C-FRAME AND CLAMP ASSEMBLY Fig. 4 Use a C-clam ...

FRONT SUSPENSION COMPONENTS 1. Stabilizer bar 2. Ball joint 3. Lower control arm 4. Tie rou eno 5. Strut and coil 6. Halfshaft ...

SUSPENSION AND STEERING 8-5 Coil Springs REMOVAL & INSTALLATION I See Figures 6, 7, 8, 9 and 10 Raise and safely support th ...

8-6 SUSPENSION AND STEERING Fig. 9 Place these components in the exact order as shown for installation Out side Fig. 10 Make sur ...

SUSPENSION AND STEERING 8-7 Fig. 13 Remove the pipe attaching to the brake hoses on the strut Loosen the two nuts on the lower ...

8-8 SUSPENSION AND STEERING Tighten the two nuts on the lower portion of the shock abdbrber to 231 ft. Ibs. (314 Nm). Tighten t ...

SUSPENSION AND STEERING 8-9 Fig. 22 The ball joint will pop out of the lower control arm Remove the cotter pin. Loosen but do n ...

8-10 SUSPENSION AND STEERING Fig. 24 Remove the front left and right side engine cove s Fig. 25 Remove the retaining nut on the ...

SUSPENSION AND STEERING 8-11 Lower Arm Bracket : Specified torque ^ Cotter Pin 4 Non-reusable part Fig. 28 View of the common fr ...

8-12 SUSPENSION AND STEERING Fig. 31 Remove the arm shaft with two wrenches, use onq to hold and another to remove the nut Fig. ...