TOYOTA PREVIA 91-97 REPAIR MANUAL

ENGINE AND ENGINE OVERHAUL 3-17

16. Connect the radiator hoses.
    17. On 1995-97 vehicles, connect the water bypass hose from the throt-
    tle body.


17. It equipped with an automatic transmission, connect the transmis-
    sion cooler lines.


18. On 1995-97 vehicles, install the power steering reservoir and
    tighten the bolts to 9 ft. IDS. (13 Nrn).


19. Install the engine under cover.


20. Install the air intake duct.


21. Lower the vehicle.


22. Connect the negative battery cable. Reset any electronic components
    such as the radio.


23. Refill the cooling system. Start the engine, bleed the cooling system,
    and check for leaks.

Engine Fan

REMOVAL & INSTALLATION

» See Figures 40 and 41

1. Remove the air duct.


2. Remove the No. 2 fan shroud.

Fig. 40 The fan blade is attached to the clutch with nuts, not all

shown

Fig. 41 Once the nuts are removed, the blade comes off easily

from the studs

3. Stretch the drive belt down and loosen the four nuts for the fan and
   clutch.


4. Remove the nuts and the fan clutch with the cooling fan.
   To install:


5. Install the fan clutch with the fan to the engine.


6. Install the fan nuts.


7. While retaining the drive belt, tighten the nuts to 10 ft. Ibs. (13
   Nm).


8. Install the No. 2 fan shroud.


9. Install the air duct.

Water Pump

REMOVAL & INSTALLATION

I See Figures 42 thru 51

1. Raise the vehicle and support safely.


2. Remove the engine under covers.


3. Drain the engine coolant.


4. Drain the engine oil.


5. Disconnect the heater hose and radiator outlet hoses.


6. Remove the oil filter bracket.

H Engino Side UnOer Cover

Fig. 42 View of the water pump and related components

Fig. 43 Unbolt and remove the oil filter bracket