TOYOTA PREVIA 91-97 REPAIR MANUAL

CHASSIS ELECTRICAL 6-19

3. Move the control levers left and right and check for stiffness or
   binding through the full range of the levers. Test control cable opera-
   tion.

Side Vent Duct

I See Figure 46

1. Set the side vent, duct and the mode control lever to VENT position,
   then install the control cable and lock the clamp.


2. Then, slide the control cable through the adjusting clip until the eye-
   let on the cable end can be engaged to the lever. Make sure the cable is
   secured.


3. Move the control levers left and right and check for stiffness or
   binding through the full range of the levers. Test control cable opera-
   tion.

(Driver's Side)

VENT

(Passenger's)

Fig. 46 Adjusting the side control vent cable

Control Panel

REMOVAL & INSTALLATION

I See Figures 47, 48 and 49

1. Disconnect the negative battery cable.


2. Remove the console box located below the ashtray.


3. Remove the ashtray retaining screws and disconnect the wiring.


4. Pull off the knobs prior to control panel removal.


5. Carefully pull out the center cluster finish panel.


6. Remove the control panel by removing the 4 screws.
   To install:


7. Installation is the reverse of removal. Use care when snapping back
   together plastic components, if so equipped.

Fig. 47 Press on the sides of the box while pulling outward to

extract the console

Fig. 48 Remove the four screws and retainer to extract the ash

tray

Fig. 49 Remove the four screws surrounding the control assem-

bly and extract the unit from the dash