CHASSIS ELECTRICAL 6-29
REMOVAL & INSTALLATION
On some models the clock is built into the radio assembly and cannot be
removed separately. On all other models proceed with the following.
- Using a small prytool, pry the clock loose from the dash panel. The
clock is usually held in the dash panel or top rear view mirror by 2 small
retaining clips. - Disconnect the electrical wiring from the rear of the clock and remove
the clock. - Installation is the reverse of the removal procedure. Check the clock
functions for proper operation. Reset the clock.
REMOVAL & INSTALLATIONThe horn is located behind the grille. Remove the grille retaining bolts
to access. Unbolt the one screw holding the horn assembly to the
bracket.LIGHTINGHeadlights
REMOVAL & INSTALLATION» See Figures 79, 80, 81, 82 and 83••This procedure only applies to replaceable halogen headlight
bulbs (such as Nos. 9004 and 9005); it does not pertain to sealed
beam units.- Open the vehicle's hood and secure it in an upright position.
- Unfasten the locking ring which secures the bulb and socket assem-
bly, then withdraw the assembly rearward. - To replace the headlight lens:
a. Remove the aiming nut located in the lower inside corner of the
assembly.
b. Pop off the spring located in the lower inside corner of the
lamp.
c. Loosen and remove the adjuster on the other side of the lens and
extract the assembly from the vehicle.
To install: - Install the new lens and secure.
- Before installing a light bulb into the socket, ensure that all electrical
contact surfaces are free of corrosion or dirt. - Line up the replacement headlight bulb with the socket. Firmly push
the bulb onto the socket.
Fig. 80 Unclasp the wiring attached to the back of the headlamp
bulb- Halogen headlight bulb
- Side marker light bulb
, I i
- Dome light bulb
- Turn signal/brake light bulb
Fig. 79 Examples of various types of automotive light bulbsIFig. 81 Twist and remove the bulb with socket from the lens
assembly