technical NOTES

14. Nuisance Bag Filter Design Pressure In a cement plant nuisance bag filters are installed at all location of transfer points ...

...

PREHEATER AND COOLER VENT FAN SELECTION CRITERIA ...

...

15. Preheater and Cooler Vent Fan Selection Criteria 15.1 Preheater Fan In earlier time the preheater fan selection mode was ver ...

potential capacity so the designed pressure of fan shall be 500 + 80 = 580 mmwg (without WHRS), to have some margin on fan to ma ...

Cooler Vent Fan Data UOM Design Data Guaranteed output @ 8000 TPD Potential Capacity output @ 9500 TPD WHRS OFF WHRS ON WHRS OFF ...

...

WASTE HEAT RECOVERY SYSTEM ...

...

WHRS SYSTEM ...

...

1. WHRS System WASTE HEAT RECOVERY SYSTEM Exhaust gas from Pre-heater being at higher elevation, the gas ducting to PH boiler wi ...

1.4 Process Flow Diagram: 1.5 AQC (Air Quenching Cooler) Boiler The flue gas, at 500- 5500C, from the mid tap of the existing gr ...

High-pressure segment low temperature super heater tube box High-pressure segment evaporator tube box Low-pressure segment supe ...

ESP Fan shall be designed with AQC Boiler and its ducting pressure drop. AQC Boiler dust conveying philosophy shall be finalize ...

SS AQC Boiler Super Heater Zone Casing to reduce the erosion rate. CFD analysis of Boilers and its ducting for minimum erosion. ...

Low-pressure economizer Each heating surface has a hammering dust removal device and dust will be collected in two hoppers. Col ...

1.12 Basic Plant Design Concept – Reliability Coils shall be of Bare tube due to sticky nature of the dust. Hammering system on ...

1.14 Dual Steam Pressure System: In Dual pressure system maximum extraction of heat value of exhaust gases is possible. In this ...