Tire and wheel- wheel and tire system
Tire and wheel
Wheel and tire system
Inspection......................................................
- Check tire.
(a) Check tire is worn and inflation pressure is proper.
Cold tire inflation pressure:
*1 It is used under the condition of speed below 160 km/h.
(b) Check tire run-out with dial indicator.
Tire run-out:
- Adjust tire position.
Hint:see adjusting position of tire shown in the dia-
gram whether there is spare tire or not.
- Check wheel balance.
(a) Check and adjust with off-the-car balancing machine.
(b) Check and adjust with in-the-car balancing machine if
necessary.
Unbalanced mass after adjusting:
- Check axial clearance of front wheel bearing
(see Page 123).
- Check end surface run-out of front wheel shaft hub
(see Page 123).
- Check axial clearance of rear wheel bearing
(see Page 129).
- Check end surface run-out of rear wheel shaft hub
(see Page 129).
- Check front suspension is loose.
- Check steering linkage is loose.
- Check ball joint is loose.
Tire size Front and rear kPa
Front
109