目录.p65

(Nora) #1
Drive shaft--Left front shaft hub assembly

Use centimeter to check the axial clearance of shaft hub center.
Maximal value: 0.05 mm
If axial clearance exceeds the maximal value, it is necessary
to change the bearing.


  1. Check the terminal face run-out of shaft hub.
    Use centimeter to check the terminal run-out of exterior sur-
    face of shaft hub.
    Maximal value: 0.05 mm
    If terminal run-out exceeds the maximal value, change the shaft
    hub.

  2. Assemble left front brake assembly [64000134]

  3. Assemble left front brake branch pump assembly
    Use two bolts to assemble brake branch pump assembly on
    steering knuckle.
    Torque: 106 ±±±±± 10 N⋅⋅⋅⋅⋅m

  4. Assemble speed sensor assembly of left front wheel


[67000020]
(a) Assemble wiring harness of speed sensor and brake hose
on the absorber with bolts.
Torque: 29 N⋅⋅⋅⋅⋅m

(b) Use the bolts to assemble speed sensor to steering knuckle.
Torque: 8.0 N⋅⋅⋅⋅⋅m
Note: Do not damage the speed sensor.
z Prevent it from contacting with sundries.
z When assembling the sensor, wiring harness of sen-
sor could not bend.


  1. Assemble fixing nut of left front drive shaft


[64000083]
(a) Assemble new fixing nuts,
Torque: 216 ±±±±± 15 N⋅⋅⋅⋅⋅m
(b) Use chisel and hammer to make fixing nut concave and fix
them.


  1. Assemble front wheels.
    Torque: 103 ±±±±± 10 N⋅⋅⋅⋅⋅m

  2. Check and adjust wheel alignment (referring to page
    87).

  3. Check the ABS speed sensor signal.


127
Free download pdf