RIScov.pag

Quick-Grip Clamp Bracket

E

VERYONEI HAVE TALKEDwith loves American Tool Companies’
Quick-Grip clamps, but they are awkward to hang. Here’s a
simple hanger bracket that efficiently stores them. Using a couple
of side-by-side sawcuts, dado a groove just over^1 ⁄ 4 in. wide and as
deep, about^3 ⁄ 4 in. from the edge of a board. Then cut slots, again just
wider than^1 ⁄ 4 in., into the board every couple of inches or so. Mount
the board on the wall or under the end of your workbench, and
hang the clamps in the slots by the little compression pins in the ends
of the bars.
—LLOYDW. WOOD,Virginia Beach,Va.

SHOP SETUP

Mount clamp bracket

to wall or bench.

Dado,^9 ⁄ 32 in.

Slots,^9 ⁄ 32 in.,

capture pins on

clamp bars.

(^3) ⁄ 4 in.