Simulink Control Design™ - MathWorks

Analysis Point Description Complementary sensitivity function Specifies an output measurement followed by an input perturbation. ...

Suppose that you want to linearize the plant P about an equilibrium operating point of the model. To linearize only the plant, y ...

In this example, if you place a loop opening at the same location as the linearization output point, the effect of the inner loo ...

Specify portion of model... Use this method if... For more Information, see... Using slTuner interface You want to obtain multip ...

Specify Portion of Model to Linearize in Simulink Model To specify the portion of the model to linearize, you can define and sav ...

2 Under Linear Analysis Points, select the type of analysis point you want to define. Input Perturbation — Specifies an additiv ...

• Output Measurement — Takes a measurement at a signal. Loop Break — Specifies a loop opening. Open-Loop Input — Specifies a l ...

Select Bus Elements as Analysis Points This example shows how to select individual elements in a bus signal as analysis points. ...

In the Select Linearization Points in the Bus dialog box, in the Bus Hierarchy section, expand the limits bus, and select upper_ ...

Filtering Options You can specify the following options when filtering the list of bus signals. Regular expression — Use MATLAB ...

(^3) To add additional analysis points from within the same bus signal, repeat step 2. To remove an analysis point, select the s ...

You can specify different analysis point types for multiple elements in the same bus. In this case, the software adds the annota ...

Specify Portion of Model to Linearize in Linear Analysis Tool To specify the portion of your Simulink model to linearize, you ca ...

1 In your Simulink model, select one or more signals that you want to define as analysis points. The selected signals appear in ...

(^2) Under Currently selected signals, click the signal you want to add. To select multiple signals, hold Ctrl and click each si ...

(^4) In the Configuration drop-down list for the signal, select the type of analysis point you want to define: Input Perturbati ...

(^5) Repeat steps 1–4 for any other signals you want to define as analysis points. TipTo highlight the source block of an analys ...

Edit Analysis Points You can interactively edit a linearization I/O set stored in the Linear Analysis Tool using the Edit dialog ...

TipTo highlight the location in the Simulink model of any signal in the current list of analysis I/O points, select the I/O poin ...

Change Analysis Point Type To change the linear analysis point type for a signal, in the Analysis I/Os section, in the Configura ...