Simulink Control Design™ - MathWorks

Cell array of finite positive real scalars for multiple natural frequency bounds. Tips To assert that the natural frequency b ...

operatingPoints — Operating points corresponding to each linear system in values. This field exists only if Save operating poin ...

See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verify Model at Default Simulation Snaps ...

Default: 'sys' See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verify Model at Default S ...

Enable assertion Enable the block to check that bounds specified and included for assertion in the Bounds tab are satisfied duri ...

Off Do not check that bounds included for assertion are satisfied during simulation. Dependencies This parameter enables: Simul ...

Type: character vector Value: '' | MATLAB expression Default: '' See Also Plot Linear Characteristics of Simulink Models During ...

Command-Line Information Parameter: stopWhenAssertionFail Type: character vector Value: 'on' | 'off' Default: 'off' See Also Plo ...

Command-Line Information Parameter: export Type: character vector Value: 'on' | 'off' Default: 'off' See Also Plot Linear Charac ...

See Also Plot Linear Characteristics of Simulink Models During Simulation on page 2-82 “Verify Model at Default Simulation Snaps ...

• Adding a legend on the linear system characteristic plot by clicking. NoteTo optimize the model response to meet design requir ...

Singular Value Plot Singular value plot of linear system approximated from nonlinear Simulink model Library Simulink Control Des ...

Evaluate a MATLAB expression. Stop the simulation and bring that block into focus. During simulation, the block can also outpu ...

Task Parameters Specify settings. In Linearizations tab: “Linearize on” on page 16-293. “Snapshot times” on page 16-294. “Trigg ...

Task Parameters (Optional) Specify bounds on singular values for assertion.In Bounds tab: Include upper singular value bound in ...

1 Click. The dialog box expands to display a Click a signal in the model to select it on page 16-290 area and a new button. 2 Se ...

To remove a signal from the Linearization inputs/outputs table, select the signal and click. TipTo find the location in the Simu ...

Configuration Type of linearization point: Open-loop Input — Specifies a linearization input point after a loop opening. Open-l ...

When this option appears, you also see the following changes: A new button. Use to add a selected signal as a linearization in ...

Off Disable use of MATLAB regular expressions for filtering signal names. Filtering treats the text you enter in the Filter by n ...