Simulink Control Design™ - MathWorks

With the linio function, you specify two linearization input points, which are both located on scalar Simulink signals. If you r ...

Close the model, the open figure, and the parallel pool. bdclose(mdl) close(gcf) delete(gcp) Parallel pool using the 'local' pro ...

More About “Managing Estimation Speed and Memory” on page 5-81 “Troubleshooting Frequency Response Estimation” on page 5-49 Se ...

...

Online Frequency Response Estimation “Online Frequency Response Estimation Basics” on page 6-2 “Online Estimation Using Plant M ...

Online Frequency Response Estimation Basics The Frequency Response Estimator block in Simulink Control Design lets you measure t ...

System Configurations for Online Frequency Response Estimation To use online frequency response estimation, you configure and de ...

As an alternative to the closed-loop configurations shown above, you can use the block in an open-loop plant, typically using a ...

“Online Estimation Using Plant Modeled in Simulink” on page 6-6 “Deploy Frequency Response Estimation Algorithm for Real-Time U ...

Online Estimation Using Plant Modeled in Simulink When you have a plant modeled in Simulink, you can perform frequency response ...

The control signal feeds into the u port of the Frequency Response Estimator block. The u Δu port feeds into the plant input. B ...

perturbation only. In this configuration, the block output contains the perturbation signal only, at the port Δu. You inject thi ...

The block provides a recommended experiment length in the Experiment Length section of the block parameters. Typically, you conf ...

During the experiment, the block updates the estimated frequency response at the frd port. The signal at this port is a vector w ...

Deploy Frequency Response Estimation Algorithm for Real-Time Use You can use the online frequency-response estimation algorithm ...

Here, the blocks connected to the inputs and outputs of the Frequency Response Estimator block represent hardware interfaces tha ...

frd — Outputs the estimated frequency responses. For more details about all ports, see the Frequency Response Estimator block ...

In this configuration, the deployed module can read frequencies and perturbation amplitudes for the estimation experiment at run ...

Step 2. Configure Start/Stop Signal To start and stop the frequency response estimation experiment, use a signal at the start/ s ...

The block provides a recommended experiment length in the Experiment Length section of the block parameters. Typically, you conf ...