Simulink Control Design™ - MathWorks

To update the PID Controller block with the tuned gains, click Update Block. Validate Controller You can examine the tuned contr ...

The controller rejects the line and load disturbances well. 7 PID Controller Tuning ...

References [1] Lee, S. W. "Practical Feedback Loop Analysis for Voltage-Mode Boost Converter." Application Report No. SLVA057. T ...

Design Controller for Power Electronics Model Using Simulated I/O Data This example shows how to design a PID controller for a p ...

In this model, a MOSFET driven by a pulse-width modulation (PWM) signal is used for switching. The output voltage Vout should be ...

To find the operating point, use the Linear Analysis Tool. To open the Linear Analysis Tool, in the Simulink model window, selec ...

Click Take Snapshots. The software simulates the model and creates an operating point that contains the input and state values o ...

To initialize the model with the computed operating point, double-click op_snapshot1. 7 PID Controller Tuning ...

In the Edit dialog box, click Initialize model. Design Controller for Power Electronics Model Using Simulated I/O Data ...

In the Initialize Model dialog box, select MATLAB Workspace, and click OK. The software exports the operating point to the MATLA ...

To identify a plant model, first obtain input/output data by simulating your model. On the Plant Identification tab, click Get I ...

In the Plant Identification document, the Input plot shows the specified input signal, and the Output plot shows the correspondi ...

To obtain a rough approximation of the identified plant, in the Identified Plant Structure plot, drag the dashed lines that corr ...

To fine-tune the approximate response, click Auto Estimate. The software estimates the parameters of the identified plant model ...

The PID Tuner updates its identified plant model, selects controller parameters to meet the tuning requirements in the Tuning To ...

Tune Controller To tune the controller based on bandwidth and phase margin, on the PID Tuner tab, in the Domain drop-down list, ...

To adjust the limits of the Bode plot, right-click the plot area, and select Properties. Then, in the Property Editor dialog box ...

To view the tuned controller parameters and performance metrics, including the gain and phase margins, click Show Parameters. Th ...

To update the PID Controller block with the tuned gains, on the PID Tuner tab, click Update Block. Validate Controller You can e ...

Simulate the model. The controller rejects the line and load disturbances well. 7 PID Controller Tuning ...