Simulink Control Design™ - MathWorks

To find the operating point that meets these specifications, on the Specification tab, click

Trim.

Synchronize Model Changes Using Linear Analysis Tool

If you change your Simulink model while the Linear Analysis Tool is open, you must

synchronize the operating point specifications in the Linear Analysis Tool to reflect the

changes in the model.

Open the Simulink model.

sys = ('scdspeedctrl');

open_system(sys)

To open the Linear Analysis Tool, in the Simulink model window, select Analysis >

Control Design > Linear Analysis.

In the Linear Analysis Tool, in the Operating Points drop-down list, select Trim

Model.

In the Trim the model dialog box, the Reference Filter block contains one state.

1 Steady-State Operating Points