Simulink Control Design™ - MathWorks

Configuration Type of linearization point:

• Open-loop Input — Specifies a linearization input point after
  a loop opening.


• Open-loop Output — Specifies a linearization output point
  before a loop opening.


• Loop Transfer — Specifies an output point before a loop
  opening followed by an input.


• Input Perturbation — Specifies an additive input to a signal.


• Output Measurement — Takes measurement at a signal.


• Loop Break — Specifies a loop opening.


• Sensitivity — Specifies an additive input followed by an
  output measurement.


• Complementary Sensitivity — Specifies an output followed
  by an additive input.

NoteIf you simulate the model without specifying an input or output, the software does

not compute a linear system. Instead, you see a warning message at the MATLAB prompt.

Settings

No default

Command-Line Information

Use getlinio and setlinio to specify linearization inputs and outputs.

See Also

Plot Linear Characteristics of Simulink Models During Simulation on page 2-82

“Verify Model at Default Simulation Snapshot Time” on page 14-6

Click a signal in the model to select it

Enables signal selection in the Simulink model. Appears only when you click.

Bode Plot