On
Show state and input/output names with their path through the model hierarchy. For
example, in the chemical reactor model, a state in the Integrator1 block of
the CSTR subsystem appears with full path as scdcstr/CSTR/Integrator1.Off
Show only state and input/output names. Use this option when the signal name is
unique and you know where the signal is location in your Simulink model. For
example, a state in the Integrator1 block of the CSTR subsystem appears as
Integrator1.Command-Line Information
Parameter: UseFullBlockNameLabels
Type: character vector
Value: 'on' | 'off'
Default: 'off'See AlsoPlot Linear Characteristics of Simulink Models During Simulation on page 2-82“Verify Model at Default Simulation Snapshot Time” on page 14-6Use bus signal names
How to label signals associated with linearization inputs and outputs on buses, in the
linear system computed during simulation (applies only when you select an entire bus as
an I/O point).Selecting an entire bus signal is not recommended. Instead, select individual bus
elements.You cannot use this parameter when your model has mux/bus mixtures.SettingsDefault: OffOn
Use the signal names of the individual bus elements.16 Blocks — Alphabetical List