Simulink Control Design™ - MathWorks

This parameter is used for assertion only if Enable assertion on page 16-173 in the

Assertion tab is selected.

The bounds also appear on the step response plot, as shown in the next figure.

Rise time Settling time

% Undershoot

% Settling

% Overshoot

% Rise

Final

value

Initial

value

If you clear Enable assertion, the bounds are not used for assertion but continue to

appear on the plot.

Settings

Default:

• Off for Linear Step Response Plot block.


• On for Check Linear Step Response Characteristics block.

On

Check that the step response satisfies the specified bounds, during simulation.

Off

Do not check that the step response satisfies the specified bounds, during simulation.

16 Blocks — Alphabetical List