Simulink Control Design™ - MathWorks

% Overshoot

The amount by which the step response can exceed the final value, specified as a

percentage.

Settings

Default:

Minimum: 0

Maximum: 100

• [] for Linear Step Response Plot block


• 10 for Check Linear Step Response Characteristics block

Real number, greater than % settling on page 16-167.

Tips

• To assert that the percent overshoot is satisfied, select both Include step response
  bound in assertion on page 16-161 and Enable assertion on page 16-173.


• To modify the percent overshoot from the plot window, drag the corresponding bound
  segment. Alternatively, right-click the segment, and select Bounds > Edit. Specify the
  new value in % Overshoot. You must click Update Block before simulating the
  model.

Command-Line Information

Parameter: PercentOvershoot

Type: character vector

Value: [] | 10 | real value between 0 and 100. Must be specified inside single quotes

('').

Default: '[]' for Linear Step Response Plot block, '10' for Check Linear Step

Response Characteristics block.

See Also

Plot Linear Characteristics of Simulink Models During Simulation on page 2-82

“Verify Model at Default Simulation Snapshot Time” on page 14-6

16 Blocks — Alphabetical List