Value: 'on' | 'off'
Default: 'off'
See Also
Plot Linear Characteristics of Simulink Models During Simulation on page 2-82
“Verify Model at Default Simulation Snapshot Time” on page 14-6
Use bus signal names
How to label signals associated with linearization inputs and outputs on buses, in the
linear system computed during simulation (applies only when you select an entire bus as
an I/O point).
Selecting an entire bus signal is not recommended. Instead, select individual bus
elements.
You cannot use this parameter when your model has mux/bus mixtures.
Settings
Default: Off
On
Use the signal names of the individual bus elements.Bus signal names appear when the input and output are at the output of the following
blocks:- Root-level inport block containing a bus object
- Bus creator block
- Subsystem block whose source traces back to one of the following blocks:
- Output of a bus creator block
- Root-level inport block by passing through only virtual or nonvirtual subsystem
boundaries
Off
Use the bus signal channel number.Pole-Zero Plot