Simulink Control Design™ - MathWorks

Command-Line Information

Parameter: UseBusSignalLabels

Type: character vector

Value: 'on' | 'off'

Default: 'off'

See Also

Plot Linear Characteristics of Simulink Models During Simulation on page 2-82

“Verify Model at Default Simulation Snapshot Time” on page 14-6

Include settling time bound in assertion

Check that the pole locations satisfy approximate second-order bounds on the settling

time, specified in Settling time (sec) <= on page 16-263. The software displays a

warning if the poles lie outside the region defined by the settling time bound.

This parameter is used for assertion only if Enable assertion on page 16-277 in the

Assertion tab is selected.

You can specify multiple settling time bounds on the linear system. The bounds also

appear on the pole-zero plot. If you clear Enable assertion, the bounds are not used for

assertion but continue to appear on the plot.

Settings

Default:

• Off for Pole-Zero Plot block.


• On for Check Pole-Zero Characteristics block.

On

Check that each pole lies in the region defined by the settling time bound, during

simulation.

Off

Do not check that each pole lies in the region defined by the settling time bound,

during simulation.

16 Blocks — Alphabetical List