Simulink Control Design™ - MathWorks

See Also

Plot Linear Characteristics of Simulink Models During Simulation on page 2-82

“Verify Model at Default Simulation Snapshot Time” on page 14-6

Include damping ratio bound in assertion

Check that the pole locations satisfy approximate second-order bounds on the damping

ratio, specified in Damping ratio >= on page 16-268. The software displays a warning if

the poles lie outside the region defined by the damping ratio bound.

This parameter is used for assertion only if Enable assertion on page 16-277 in the

Assertion tab is selected.

You can specify multiple damping ratio bounds on the linear system. The bounds also

appear on the pole-zero plot. If you clear Enable assertion, the bounds are not used for

assertion but continues to appear on the plot.

Settings

Default: Off

On

Check that each pole lies in the region defined by the damping ratio bound, during

simulation.

Off

Do not check that each pole lies in the region defined by the damping ratio bound,

during simulation.

Tips

• Clearing this parameter disables the damping ratio bounds and the software stops
  checking that the bounds are satisfied during simulation. The bounds are also greyed
  out on the plot.

16 Blocks — Alphabetical List