Simulink Control Design™ - MathWorks

• Linearize At — Simulate the model using the model initial conditions, and use the
  simulation snapshot at the specified time as the operating point. For more information,
  see “Linearize at Simulation Snapshot” on page 2-96.


• Linearize at Multiple Points — Select multiple previously created operating
  points.


• Existing Operating points — Select a previously created operating point.


• Trim Model — Compute a steady-state operating point. For more information, see
  “Compute Steady-State Operating Points” on page 1-6.


• Take Simulation Snapshot — Simulate the model using the model initial
  conditions, and compute an operating point at the specified simulation snapshot times.
  For more information, see “Find Operating Points at Simulation Snapshots” on page 1-
  108.


• View/Edit — View or edit the currently selected operating point.

Parameter Variations — Parameters to vary for batch linearization

None (default) | parameters to vary

To vary parameters for batch linearization, in the drop-down list, click Select

parameters to vary. On the Parameter Variations tab, specify the parameters to

vary.

For more information, see “Specify Parameter Samples for Batch Linearization” on page

3-62.

Result Viewer — Open linearization result viewer

cleared (default) | checked

Select to display result details after linearization. For more information, see “View

Linearized Model Equations Using Linear Analysis Tool” on page 2-149.

Linearization Advisor — Collect diagnostic information and open

Linearization Advisor

cleared (default) | checked

Select to collect diagnostic information during linearization and open an Advisor tab for

interactive troubleshooting of linearization problems. For more information, see

“Troubleshoot Linearization Results in Linear Analysis Tool” on page 4-23.

19 Apps — Alphabetical List