Simulink Control Design™ - MathWorks

Operating Point — Linearization operating point

Model Initial Condition (default) | operating point

Linearization operating point. The current operating point is displayed. To change the

operating point, select one of the following:

• Model Initial Condition — Use the initial conditions defined in the Simulink.


• Linearize At — Simulate the model using the model initial conditions, and use the
  simulation snapshot at the specified time as the operating point. For more information,
  see “Linearize at Simulation Snapshot” on page 2-96.


• Linearize at Multiple Points — Select multiple previously created operating
  points.


• Existing Operating points — Select a previously created operating point.


• Trim Model — Compute a steady-state operating point. For more information, see
  “Compute Steady-State Operating Points” on page 1-6.


• Take Simulation Snapshot — Simulate the model using the model initial
  conditions, and compute an operating point at the specified simulation snapshot times.
  For more information, see “Find Operating Points at Simulation Snapshots” on page 1-
  108.


• View/Edit — View or edit the currently selected operating point.

Result Viewer — Open estimation result viewer

cleared (default) | checked

Select to display result details about the estimation configuration and input signal used

for estimation.

Diagnostic Viewer — Collect diagnostic information and open diagnostic viewer

cleared (default) | checked

Select to collect diagnostic information that displays after estimation. You can use the

diagnostic information to analyze the estimation result and troubleshoot estimation

problems. For more information, see “Analyze Estimated Frequency Response” on page 5-

23.

NoteThe Linear Analysis Tool only collects diagnostic information when Diagnostic

Viewer is selected before performing an estimation task.

19 Apps — Alphabetical List