143
© 2009, AWI, AWMAC, WI - Architectural Woodwork Standards - 1st Edition, October 1, 2009
As may be updated by errata at http://www.awinet.org, http://www.awmac.com, or http://www.woodworkinstitute.com/awserrata/Section 6 - Interior & Exterior Millwork (Page 22 of 31)
PRODUCT
MATERIAL, MACHINING, AND ASSEMBLY RULES (continued)
DESCRIPTION E C P
4.4
A S S E M B L Y
ASSEMBLY (continued)
4.4.11SASH (continued)
4.4.11.3 At DOUBLE-GLAZED units requires one stop to be left loose for finishing.
4.4.11.4 If GLASS is furnished and installed, it shall conform to the requirements set herein.
4.4.12 BLINDS and SHUTTERS is required, with:
4.4.12.1 Dadoed or equivalent joinery.
4.4.13 SCREENS is required, with:
4.4.13.1 Them assembled under pressure and pinned.
4.4.14O R N A M E N T A L M I L L W O R K
ORNAMENTAL MILLWORK:
4.4.14.1 WOODWORK shall be manufacturer-sized except where installer adjustments are required.
4.4.14.2 COLUMN fabrication for opaque finish shall allow finger-joints, with:
4.4.14.2.1 Maximum of one per 96" (2400 mm) or portion thereof in any individual member.
4.4.14.2.2 Joints offset a minimum of 3" (76 mm) from adjacent joints.4.4.14.2.3 Joints perpendicular to the face of the column resulting in the appearance of a single horizontal line with column upright.4.4.14.2.4 Compliance Tests C and Flushness shall apply to such joints.
4.4.14.3S H E E T P R O D U C T S
SHEET PRODUCTS
4.4.14.3.1 Of SOLID LUMBER shall be:
4.4.14.3.1.1 Edge-glued for width. M
4.4.14.3.1.2 Maximum 10" (254 mm) in width. M
4.4.14.3.1.3 Not permitted. M
4.4.14.3.2 With RAISED PANEL RIMS:
4.4.14.3.2.1 Mitered and glued to sheet product body. MM
4.4.14.3.2.2 Mitered, splined, or doweled to sheet product body. M
4.4.14.3.3 With PANEL PRODUCT CENTERS require:
4.4.14.3.3.1 No edge treatment. M
4.4.14.3.3.2 Edge covered by veneer or concealed by molding. MM
4.4.14.3.4 With LOOSE JOINTS between sections require:
4.4.14.3.4.1 No preparation. M4.4.14.3.4.2Manufacturer preparation, utilizing mortise and tenon,
dowel, or spline joinery. M4.4.14.3.4.3Manufacturer assembly (if practical), utilizing mortise and
tenon, dowel, or spline joinery. M
4.4.14.3.5 With OUTSIDE CORNERS require:
4.4.14.3.5.1 No preparation. M4.4.14.3.5.2 Manufacturer prepared and shipped loose for installer
fitting.M4.4.14.3.5.3 Manufacturer prepared, glued, and braced (if practical). M
4.4.14.3.6 With INSIDE CORNERS require:
4.4.14.3.6.1 No preparation. M
4.4.14.3.6.2 Shipped oversize for installer fitting. MM6