AWS EDITION 1, 2009

242

© 2009, AWI, AWMAC, WI - Architectural Woodwork Standards - 1st Edition, October 1, 2009

As may be updated by errata at http://www.awinet.org, http://www.awmac.com, or http://www.woodworkinstitute.com/awserrata/

COMPLIANCE

7 FABRICATED and INSTALLED (continued)

7.2 GAPS, FLUSHNESS, and FLATNESS of product and installation (continued)

7.2.2 Joint length shall be measured with a ruler with minimum 1/16” (1 mm) divisions and calculations made

accordingly.

7.2.3 Reasonable assessment of the performance of the finished product will be weighed against absolute compliance

with the standards.

7.2.4 The following is intended to provide examples of how and where compliance testing is measured:

SQUARENESS

A

C

B

D

B

D

F

F

E

E

Measured on the concave face

A - Gaps when surfaces are mitered or butted

B - Gaps when parallel pieces are joined

C - Gaps when edges are mitered or butted

D - Flushness between two surfaces

E - Flatness of panel product

F - Flushness of edgebanding

G - Chipout

H - Show-through or telegraphing

Section 9 - Doors (Page 37 of 37)

H

G

9