SolidWorks 2010 Bible
Chapter 27: Working with Surfaces Extend Surface The Extend Surface feature functions much in the same way that the Extend funct ...
Part VI: Using Advanced Techniques When you use surface bodies to trim one another, you must select one of two options: Standard ...
Chapter 27: Working with Surfaces FIGURE 27.10 The Fill Surface PropertyManager and the results of applying it You can set bound ...
Part VI: Using Advanced Techniques FIGURE 27.11 The Fill Surface feature with constraint curves MidSurface The MidSurface featur ...
Chapter 27: Working with Surfaces FIGURE 27.12 The MidSurface PropertyManager If you were to manually perform the functions that ...
Part VI: Using Advanced Techniques FIGURE 27.13 Using Replace Face Ruled Surface Ruled Surfaces are discussed in general in the ...
Chapter 27: Working with Surfaces FIGURE 27.14 The Ruled Surface PropertyManager interface The Ruled Surface works from the edge ...
Part VI: Using Advanced Techniques The Perpendicular to Vector setting is a better option than the Normal to Surface setting whe ...
Chapter 27: Working with Surfaces FIGURE 27.15 Using the Up To Body setting FIGURE 27.16 Extruding text Cut With Surface Sometim ...
Part VI: Using Advanced Techniques FIGURE 27.17 Using the Cut With Surface feature on a part When cutting with a surface, the ed ...
Chapter 27: Working with Surfaces FIGURE 27.18 Using Replace Face Note The Fill Surface is an advanced surfacing function. Somet ...
Part VI: Using Advanced Techniques FIGURE 27.19 Blending with the Fill Surface FIGURE 27.20 The Fill PropertyManager for merging ...
Chapter 27: Working with Surfaces If you had to go through these steps manually, then you would use the Replace Face feature to ...
Part VI: Using Advanced Techniques Using Cut With Surface Follow these steps to gain some experience with the Cut With Surface f ...
Chapter 27: Working with Surfaces Using Offset Surface Follow these steps to gain some experience with the Offset Surface: Open ...
Part VI: Using Advanced Techniques FIGURE 27.24 Extruding with the Up To Body setting Tip It is preferable to select the surface ...
Chapter 27: Working with Surfaces FIGURE 27.25 An extruded cut Using Fill Surface blend Sometimes fillets do not meet your needs ...
Part VI: Using Advanced Techniques FIGURE 27.26 Using split entities to split lines FIGURE 27.27 Split ends after trimming Init ...
Chapter 27: Working with Surfaces Create Lofted Surfaces all the way around the part, linking all the tubes. Figure 27.28 shows ...
Part VI: Using Advanced Techniques Select the Merge result option, but leave the Try to form solid option unselected. The model ...
«
41
42
43
44
45
46
47
48
49
50
»
Free download pdf