Chapter 3: Working with Sketches
has created virtual sharps. Figure 3.41 shows the sketch at this point. You may now want
to turn off the Sketch Relations display because the screen is getting pretty busy. You can
find this setting at View ➪ Sketch Relations.
FIGURE 3.41
The resulting sketch after you perform Step 9
- Draw a line starting from the midpoint of the angled line. The midpoint should high-
light when you move the cursor close to it. Draw the line perpendicular to the angled
line. A dotted yellow line appears, showing where the perpendicular lies. When you fol-
low this line, the yellow perpendicular symbol appears on the cursor. Make this line
approximately .25 inches long. Feedback on the cursor also shows the length of the line
as you draw it.
- Draw two more lines ending at the endpoint of the sketch fillet, as shown in Figure
3.42. Use the Inferencing lines to line up the second angled line with the end of the arc.
FIGURE 3.42
The resulting sketch after you perform Step 11
