SolidWorks 2010 Bible

Chapter 17: Using Hole Wizard and Toolbox

FIGURE 17.21

A section view of the tutorial assembly

1. Open the assembly from the CD-ROM called Chapter 17 Tutorialstart.
   sldasm.


2. Make sure that the Toolbox Browser is turned on by choosing Tools ➪ Add-Ins ➪
   SolidWorks Toolbox and ➪ SolidWorks Toolbox Browser.


3. Expand the Task pane, found on the right side of the graphics window, and display
   the Design Library panel, which contains the Toolbox icon. Expand the ANSI Inch
   standard, and the Bolts and Screws folder, and finally click the Hex Head bolt, as shown
   on the left in Figure 17.22. Drag-and-drop the Hex bolt into any hole. It snaps into place
   because of the Mate Reference that is used on the Toolbox part. Toolbox should automat-
   ically size the bolt correctly. Click the green check when you are done, then click the red
   X to finish placing bolts.