Architectural and Engineering Design Standards

Rev. 13 November 1, 2016

Page | 39

4.10 Division 10 – Specialties

10 14 00 Signage

1. The preferred plaque for LEED accredited facilities is the “Polished Water Jet Cut Aluminum - Clear Coated”
   plaque.

10 21 13 Toilet Compartments

2. Toilet compartments shall be stainless steel or solid surface and ceiling hung.


3. Hardware for toilet compartments shall have a safety release latch that allows the door to be opened from the
   outside in the case of an emergency

10 21 23 Cubicles

10 21 23.13 Cubicle Curtains: Comply with NFPA 13. Mesh extensions of 18” required on top of

curtain. Get Owner approval for chosen design.

10 21 23.16 Cubicle Track and IV Track: Surface mounted track and carrier assemblies: “On the Right Track,”

General Cubicle or Owner approved equal.

10 22 00 Fire Rated Folding Partition

1. Horizontal Sliding partition, 1-hour fire rated, STC 50. Won Door Fireguard Model 20.


2. Closing systems shall be automatic composed of a microprocessor control box, key switch module, motor drive
   unit and leading edge obstruction detector


3. The microprocessor control box and key switch module shall be accessible whether the door is open or closed.

10 22 26 Operable Partitions

1. Manual or electric, accordion, STC 39, Modernfold Soundmaster 8 or Skyfold.

10 26 00 Corner Guards

1. Corner guards to be Koroseal GS25, 2 ½” Stainless Steel. The corner guards should sit at top of resilient base.
   The resilient base is not to run across the corner guard. The top of the corner guard should be 1/4" below
   suspended grid ceiling.

10 26 33 Kickplates: Screwed on, stainless steel, US 26D.

10 28 00 Toilet and Bath Accessories

1. Manufacturers: Bobrick, Bradley or American Specialties. Units listed below are based on Bobrick. Other
   manufacturer’s models must be equal to the listed Bobrick models.
   a) Soap dispensers – Softcare Soap Dispenser, Model #05613 – 4.5”w x 7.5” h x 4.25”d.