3 Near the bottom of the Create Biped rollout, change Toes to 1 and Toe
Links to 1.
When you inspected the model earlier, you found that Wilson has three
fingers and a thumb for a total of four fingers. The fingers are short, so
only two finger links are needed.4 Set Fingers to 4 and Finger Links to 2.
Wilson's neck is rather stubby, so he needs only one neck link.5 Set Neck Links to 1.Position the biped:
1 Open the Motion panel.2 In the Biped rollout, click Figure mode to turn it on.
If the Biped rollout doesn’t appear on the Motion panel, select any part
of the biped to make it appear.IMPORTANTBe sure to turn on Figure mode before continuing. Figure mode
will retain the pose you are about to create.3 Select the center of mass (COM), the blue tetrahedron at the center of
the biped’s pelvis.TIP You can quickly select the COM by clicking any of the
selection buttons in the Track Selection rollout: Body Horizontal, Body Vertical,
or Body Rotation.4 In the Front viewport, move the COM to the center of the model’s hips.Aligning the Biped to the Model | 897