Engineering Fundamentals: An Introduction to Engineering, 4th ed.c

Problems 535

For Problems 16.1 through 16.10, draw the top, the front, and

the right-side orthographic views of the objects are shown. Indi-

cate when an object needs only one or two views to be fully

described.

16.1.

16.2.

16.3.

Problem 16.1

Source:From MADSEN. Engineering Drawing and Design, 4E.

© 2007 Delmar Learning, a part of Cengage Learning, Inc.

Reproduced by permission. http://www.cengage.com/permissions

Problems

16.4.

16.5.

16.6.

Problem 16.3

Source:From MADSEN. Engineering Drawing and Design, 4E.

© 2007 Delmar Learning, a part of Cengage Learning, Inc.

Reproduced by permission. http://www.cengage.com/permissions

Problem 16.2

Source:From MADSEN. Engineering Drawing and Design, 4E.

© 2007 Delmar Learning, a part of Cengage Learning, Inc.

Reproduced by permission. http://www.cengage.com/permissions

Problem 16.4

Source:From MADSEN. Engineering Drawing and Design, 4E.

© 2007 Delmar Learning, a part of Cengage Learning, Inc.

Reproduced by permission. http://www.cengage.com/permissions

Problem 16.5

Source:From MADSEN. Engineering Drawing and Design, 4E.

© 2007 Delmar Learning, a part of Cengage Learning, Inc.

Reproduced by permission. http://www.cengage.com/permissions

Problem 16.6

Source:From MADSEN. Engineering Drawing and Design, 4E.

© 2007 Delmar Learning, a part of Cengage Learning, Inc.

Reproduced by permission. http://www.cengage.com/permissions

62080_16_ch16_p504-549.qxd 5/22/10 12:31 AM Page 535

Copyright 2010 Cengage Learning. All Rights Reserved. May not be copied, scanned, or duplicated, in whole or in part. Due to electronic rights, some third party content may be suppressed from the eBook and/or eChapter(s).

圀圀圀⸀夀䄀娀䐀䄀一倀刀䔀匀匀⸀䌀伀䴀圀圀圀⸀夀䄀娀䐀䄀一倀刀䔀匀匀⸀䌀伀䴀