RX8--Transmission (Manual & Auto)

Remove the interlock cable from the selector lever. Fully pull the end of the interlock cable to the selector lever. Remove the ...

Install the interlock cable end to the interlock link on the selector lever. Fit the interlock cable in the U-groove in the sel ...

Connect the brake switch connector with the brake pedal released. CAUTION: The clearance between the brake switch and the bra ...

If there is any malfunction, adjust the TR switch. (See TRANSMISSION RANGE (TR) SWITCH ADJUSTMENT .) Verify that the vehicle ...

Disconnect the negative battery cable. Remove the following parts. a. Ashtray (See CONSOLE REMOVAL/INSTALLATION .) b. Console ...

(See EXHAUST SYSTEM REMOVAL/INSTALLATION .) Shift the selector lever to the P position. Remove in the order indicated in the ta ...

(See Manual Shaft Lever Component Removal Note .) (See Manual Shaft Lever Component Installation Note .) 2 Clip 3 Shift knob 4 C ...

Push the snap pin into hole B and hole C of the lock unit until it passes through. Disconnect the brake switch connector. Remov ...

Fit the interlock cable in the U-groove in the selector lever base plate, and install the clip. Press the interlock cable lock ...

CAUTION: The clearance between the brake switch and the brake pedal is automatically adjusted to the correct amount when the br ...

Remove the steering shift switch. (See AUDIO CONTROL SWITCH REMOVAL/INSTALLATION .) Install in the reverse order of removal. S ...

spring Down switch on 2.48 TCM Up switch and down switch on 1.50 spring Inspect TCM Inspect related harness (w) RX-8 Transmi ...

OIL SEAL (DIFFERENTIAL) OIL SEAL REPLACEMENT Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION .) Remove the ba ...

Using the SST and a hammer, tap the new oil seal in evenly until the SST contacts the extension housing. Coat the lip of the oi ...

CONTROL VALVE BODY CONTROL VALVE BODY REMOVAL On-Vehicle Removal WARNING: A hot transmission and ATF can cause severe burns. Tu ...

CONTROL VALVE BODY INSTALLATION On-Vehicle Installation CAUTION: Do not move the manual valve in the direction of arrow to prev ...

Tightening torque o 7.09.0 N·m {7291 kgf·cm, 6378 in·lbf} Connect the negative battery cable. Install the battery cover. Ins ...

EXTENSION HOUSING AND PARKING MECHANISM EXTENSION HOUSING, PARKING MECHANISM REMOVAL/INSTALLATION Remove the engine cover. (See ...

1 Extension housing (See Extension Housing Removal Note .) (See Extension Housing Installation Note .) 2 Bearing 3 Spacer, ball ...

Tightening torque o 10.814.7 N·m {1.11.4 kgf·m, 8.010.8 ft·lbf} Add ATF and, with the engine idling, inspect the ATF level a ...